View previous topic :: View next topic |
Author |
Message |
Sam K
Joined: 11 Nov 2008 Posts: 14 Location: Manchester, UK
|
Posted: Sun Jan 11, 2009 2:03 am Post subject: Mains power and odd ring. |
|
|
Does anyone know what the ring that comes with the mains adapter is ment to do? It seems to be to stop you using full power but I don't see how it actually works, i.e. it doesn't actually do that.
My japanese is non existant so I can't read the instructions.
Thanks |
|
Back to top |
|
|
B 67
Joined: 23 Sep 2008 Posts: 277 Location: Stratford, Australia
|
Posted: Sun Jan 11, 2009 3:49 am Post subject: |
|
|
I'm not sure about it either. All it seems to do is allow easier fine adjustment of speed by enlarging the diameter of the speed control knob. I haven't found that it restricts the movement of it at all. _________________ Darren,
Stratford,
Australia. |
|
Back to top |
|
|
David-Tk
Joined: 10 Dec 2008 Posts: 3 Location: Tokyo, Japan
|
Posted: Mon Jan 12, 2009 5:56 pm Post subject: Re: Mains power and odd ring. |
|
|
Sam K wrote: | Does anyone know what the ring that comes with the mains adapter is ment to do? It seems to be to stop you using full power but I don't see how it actually works, i.e. it doesn't actually do that.
My japanese is non existant so I can't read the instructions.
Thanks |
If my translation of the instructions is correct, it goes something like this:
"If desired, set the adjuster on the position right before the train sets into motion/starts running."
and
"Set the adjuster on the power box's speed controller" |
|
Back to top |
|
|
Sam K
Joined: 11 Nov 2008 Posts: 14 Location: Manchester, UK
|
Posted: Wed Jan 14, 2009 12:04 am Post subject: |
|
|
Thanks David-TK
Quote: | set the adjuster on the position right before the train sets into motion/starts running |
So they seem to be saying that you set it to stop the knob being turned down beyond a point just below where the train starts to move.
This would be because the trains don't move until you have moved the knob some way above its minimum position and you could otherwise loose this point at which it does start to move.
Anyone understand the above? or is my babling as bad (or worse ) as the straight translation from Japanese gramar |
|
Back to top |
|
|
charliemeinershagen
Joined: 14 Nov 2008 Posts: 12 Location: Redding, California
|
Posted: Wed Jan 14, 2009 9:24 am Post subject: Ring |
|
|
T-gaugers,
I don't think it does anything. That's my two cents worth.
Charlie |
|
Back to top |
|
|
B 67
Joined: 23 Sep 2008 Posts: 277 Location: Stratford, Australia
|
Posted: Sat Jan 17, 2009 11:13 am Post subject: |
|
|
Okay, I tried it the way suggested earlier. Finding the point on the speed knob at which the train stops. And then adding the ring so that it stops the speed knob being moved further anti-clockwise. Which it only does if you turn the ring rather than the knob.
And it works. The trains started moving almost as soon as you turn the speed control clockwise. Also the head and tail lights didn't go off - just dimmed. Seems okay. My concern would be whether the voltage still on the rails could damage the motor when the train is not running. Probably not, but being so tiny, perhaps it could.
Any thoughts? _________________ Darren,
Stratford,
Australia. |
|
Back to top |
|
|
|